Comments on: Basic EFI Tune-Up

By: craig

craig — Sat, 24 Jan 2009 02:53:44 +0000

The first step is to bridge the STI and GND terminals of the service connector. From memory it’s located near the fuse panel in the lower part of the drivers side dash.
Start the engine and wait two minutes and then set the timing to 0 +/-2 degrees btdc (six cylinder) and 30 +/-2 degrees for the V8. Remove the bridge and all should be good.

By: craig

craig — Sat, 24 Jan 2009 02:21:33 +0000

Sure Rob, do you have the 4.0 litre six cylinder or the 5.0 litre V8?

By: Rob

Rob — Sat, 24 Jan 2009 01:56:47 +0000

Trying to find the correct procedure for checking engine timing on an EL Fairlane. Have the tools needed but can’t remember the Timing for this vehicle. Can u hepl me with this?
Thx
Rob

By: oxygen sensor blog

oxygen sensor blog — Fri, 10 Aug 2007 06:36:15 +0000

A faulty oxygen sensor increases fuel intake and gas mileage too.